# Heat pump maintenance in Boston, MA

> A yearly visit for ducted heat pumps: filter, coils, condensate, defrost, charge and airflow checked against the startup readings, priced per system.

URL: https://clementbostonheatpumps.com/heat-pump-maintenance/

Service

A yearly check of filters, coils, drains, defrost, charge and airflow on ducted heat pumps.

(857) 837-1475

Last Updated: November 12, 2026

Sized

From a room-by-room load calculation at your town's design temperature

Measured

Duct static pressure and airflow before and after

Tested

Nitrogen pressure test and deep vacuum before the charge

In writing

Equipment, duct work, electrical and permits listed line by line

## What a heat pump maintenance visit in Mattapan looks like

Outdoor coil matted with cottonwood before the rinse

Checking static pressure at the basement air handler

### The system

A ducted heat pump in a Mattapan colonial, about six years old: a 3-ton outdoor unit on a stand beside the driveway and a variable-speed air handler with a 4-inch media filter in the basement. It runs longer than it used to in September, and the float switch shut it off once in July.

### Inside

The filter is loaded, and static pressure reads 0.78 inch against 0.52 on the commissioning sheet; a new filter brings it to 0.55. Slime in the condensate trap is what tripped the float switch, so we flush the trap and line, test the switch and check the drain's slope to the floor drain.

### Outside

Cottonwood and leaves mat the coil on the driveway side. With the power off, we rinse it from the inside out at low pressure and straighten the bent fins. Then, running in heating, we force a defrost cycle and watch it start and finish cleanly, and check that the stand is still level.

### Charge and electrical

Superheat and subcooling sit inside the maker's range, so no refrigerant goes in or out. The run capacitor reads 43 microfarads on a 45 rating, inside tolerance, so it goes on the report to recheck next year instead of being replaced. The backup heat lockout is still at 20°F.

*Project facts*

| Service | Annual heat pump maintenance |
| --- | --- |
| Where | Mattapan |
| House | Two-story colonial, one ducted system |
| Before | Loaded filter, slimed trap, matted coil |
| After | Static back to 0.55 inch, drain clear, defrost checked |
| Price | $265 for the visit |
| Time on site | About two and a half hours |

A ducted heat pump heats all winter and cools all summer, so it runs far more hours than the furnace or air conditioner it replaced. [Clement Boston Heat Pumps](https://clementbostonheatpumps.com/) handles heat pump maintenance in Boston and the towns around it: one visit a year that checks the parts that wear and compares the readings with the day the system started.

We price a visit per system, set before we come, with attic air handlers and second systems listed on their own. Anything that needs a part goes on the written report with its own price.

## What a heat pump maintenance visit covers

Inside, the filter, blower, coil, drain and controls. Outside, the coil, clearance, stand and defrost. Then the readings that matter, compared with your commissioning sheet.

### Inside, at the air handler

A loaded filter is the simplest way for a ducted heat pump to lose airflow. We replace it, check the blower wheel and the indoor coil for dust, and flush the condensate trap and line. Slime in the trap is what trips the float switch and shuts the system off on a humid July day.

### Outside, at the unit

The outdoor coil collects leaves, cottonwood and road grit. We rinse it from the inside out at low pressure, straighten bent fins, and check that the stand is level and high enough to clear drifting snow. The [snow stand guide](https://clementbostonheatpumps.com/guide/heat-pump-snow-stand/) covers heights.

### The defrost cycle

In heating, the outdoor coil frosts in cold, damp air, and the unit reverses for a few minutes to melt it. We force a defrost and watch it start, clear the coil and end. Light frost and a puff of steam are normal; ice that grows into a block is not.

## Why we measure instead of topping off

A heat pump is a sealed system. If it’s low on refrigerant, it has a leak, and adding refrigerant without finding it only delays the next call.

We read suction and liquid pressures and line temperatures, work out superheat and subcooling, and compare them with the maker’s chart. In range, nothing goes in or out. Out of range, the report says so, and finding the leak becomes a [heat pump repair](https://clementbostonheatpumps.com/heat-pump-repair/) with its own price.

### Airflow against the commissioning sheet

Every system we install leaves with its static pressure and airflow on record. At each maintenance visit we measure again. A rise in static points to the filter, a dirty coil or a closed damper, and it’s the early warning that the blower is working too hard. Our [ductwork page](https://clementbostonheatpumps.com/heat-pump-ductwork/) covers the fixes when the ducts themselves are the problem.

### Systems installed by others

We maintain ducted heat pumps someone else installed too. With no commissioning sheet, the first visit becomes the baseline we compare against next year.

## When to schedule it in Boston

Once a year is enough for most ducted systems. Early fall works well: the summer debris comes off the coil and the defrost is tested before the first cold snap.

- **Near the water.** In East Boston, South Boston, [Winthrop](https://clementbostonheatpumps.com/service-areas/winthrop/), [Revere](https://clementbostonheatpumps.com/service-areas/revere/) or along the [Quincy](https://clementbostonheatpumps.com/service-areas/quincy/) shore, salt film builds on the outdoor coil. Makers of coastal units recommend a fresh-water rinse, so we add one in spring.
- **Under trees.** Cottonwood in June and leaves in October mat the coil, and a second rinse is worth it.
- **Attic air handlers.** The secondary pan and float switch matter most there, because a leak shows up in the ceiling below. See [attic air handlers](https://clementbostonheatpumps.com/attic-air-handler-heat-pump/).
- **Pets and renovation dust.** Both load filters fast; check them monthly.

## What the visit finds and what happens next

Most findings are fixed during the visit: a filter, a flushed drain, a rinsed coil. Anything that needs a part is written up with its reading and a price.

| Reading | What it tells us | What happens |
| --- | --- | --- |
| Static pressure up since startup | Filter, coil or damper restricting air | Cleaned during the visit, or a duct fix priced |
| Superheat or subcooling out of range | A leak or a metering problem | Repair priced on the report |
| Capacitor below its rating | A part starting to fail | Replaced now or rechecked next year, depending on the reading |
| Aux heat running above the lockout | A setting or sensor problem | Lockout reset and recorded |

## What the written report gives you

You leave the visit with numbers, not a checklist of ticks. Each reading sits beside last year’s, so a slow drift shows up before it becomes a no-heat call in January.

- **Static pressure and airflow**, next to the commissioning figures or last year’s baseline.
- **Superheat and subcooling**, with the outdoor temperature they were read at.
- **Capacitor and amp readings** for the compressor and the outdoor fan.
- **Filter size and type**, so you can buy the right one between visits.
- **Lockout and thermostat settings**, as found and as left.
- **Anything that needs a part**, with its own price, so you decide what happens next.

### Dual-fuel systems

On a [dual-fuel heat pump](https://clementbostonheatpumps.com/dual-fuel-heat-pump/), the visit covers the heat pump, the coil on the furnace and the switchover setting. The furnace burner itself needs its own yearly service from a heating contractor.

## What you can do between visits

Change the filter, keep the outdoor unit clear, and leave the settings alone. Those three cover most of what goes wrong between visits.

Check the filter monthly in deep winter and midsummer. Keep snow, leaves and shrubs clear around the outdoor unit, and never chip ice off the coil. If aux heat shows on a mild day, call rather than turning the thermostat up; our [aux heat guide](https://clementbostonheatpumps.com/guide/heat-pump-aux-heat/) explains why.

### Maintenance and how long a system lasts

Maintenance doesn’t guarantee a lifespan, but a clean coil, a clean filter and a correct charge keep the compressor out of the conditions that wear it fastest. Keep the reports: some manufacturer warranties ask for maintenance records. The [lifespan guide](https://clementbostonheatpumps.com/guide/heat-pump-lifespan/) covers what shortens a system’s life, and [heat pump replacement](https://clementbostonheatpumps.com/heat-pump-replacement/) covers the end of it.

## What's included

- Filter checked and replaced, with the filter slot sealed
- Blower, indoor coil and drain pan inspected; the coil cleaned when it needs it
- Condensate trap and line flushed, float switch tested
- Outdoor coil rinsed, fins straightened, clearance and stand checked
- A forced defrost cycle watched from start to finish
- Pressures and temperatures read against the maker's range
- Electrical connections, contactor and capacitor tested
- Static pressure and airflow compared with the commissioning sheet
- Thermostat settings and the backup heat lockout checked
- A written report with the readings and anything that needs a repair price

## Who does what to keep a ducted heat pump running

|  | You, through the year | Our yearly visit | A repair visit |
| --- | --- | --- | --- |
| Filter | Check monthly in deep winter and midsummer | Replaced and the slot sealed | Checked first, since a clogged filter mimics other faults |
| Outdoor unit | Keep snow, leaves and shrubs clear around it | Coil rinsed, fins straightened, stand checked | Ice, noise or a unit that won't start traced to the cause |
| Condensate | Watch for water around the air handler | Trap and line flushed, float switch tested | An overflow or tripped switch fixed |
| Refrigerant | Nothing to do | Read by pressures and temperatures | The leak found and repaired before any charge goes in |
| Controls | Leave the lockout settings alone | Lockout and schedules checked | Faults and error codes diagnosed |

## Related resources

- [Learn**How long does a heat pump last?** No one can promise a heat pump a number of years. What you can control is the install, the sizing and the upkeep that decide most of it.](https://clementbostonheatpumps.com/guide/heat-pump-lifespan/)
- [Learn**Why does my heat pump's aux heat keep coming on?** Backup heat is part of every cold-climate system. Here's when it should run, when it shouldn't, and the settings that decide which.](https://clementbostonheatpumps.com/guide/heat-pump-aux-heat/)
- [Learn**How high should a heat pump snow stand be, and where should the outdoor unit go?** The outdoor unit pulls heat from winter air, so snow, ice, salt and the neighbors all shape where it goes and what it sits on.](https://clementbostonheatpumps.com/guide/heat-pump-snow-stand/)
- [Learn**What happens during a heat pump installation?** Each step in a ducted install depends on the one before it. Here's the order, why it runs that way, and how you can tell the job was done right.](https://clementbostonheatpumps.com/guide/heat-pump-installation-process/)
- [Learn**What does the switch to R-454B refrigerant mean for my heat pump?** New ducted heat pumps use lower-impact refrigerants. Here's why, what it changes when you repair or replace a system, and what it doesn't.](https://clementbostonheatpumps.com/guide/heat-pump-refrigerant-r454b/)

## How a job runs

### First call

You tell us what heats and cools the house now, which rooms aren't working, and roughly where the house is.

### Home visit

We measure the house for a load calculation, test the ducts, check the panel and look for an outdoor spot.

### Written estimate

Equipment, duct changes, electrical, permits and the rebate path, line by line, with our price.

### Install

Permits first, then the work: usually two to five working days on site.

### Commissioning

Pressure test, vacuum, charge by weight, airflow and controls set before we call it done.

## Heat pump maintenance: questions

### How often does a ducted heat pump need maintenance?

Once a year for most houses, plus a filter check every month in deep winter and midsummer. Houses near salt water or under cottonwoods and oaks benefit from a second coil rinse. Early fall is a good time, before the defrost cycle starts working hard.

### Do you maintain heat pumps someone else installed?

Yes, if it's a ducted heat pump. Without a commissioning sheet from the original installer, the first visit records static pressure, airflow and refrigerant readings as the baseline, and every visit after that is compared against it.

### Should a maintenance visit add refrigerant?

No. A heat pump is sealed, so a correct charge stays correct. We read pressures and temperatures, and if the charge is low the report says there's a leak to find. Adding refrigerant without a repair just puts off the next call.

### What can I do myself between maintenance visits?

Change or check the filter, keep snow, leaves and shrubs clear around the outdoor unit, and never chip ice off the coil, because the fins fold. Leave the thermostat's backup heat settings as they were set at startup.

### How do you price a heat pump maintenance visit?

Per system, set before the visit. Where the air handler sits (a basement closet or an attic), how many systems the house has and the filter type decide it. Anything that needs a part goes on the report with its own price.

## Related services

- [Service**Heat pump repair** Ducted heat pumps that won't heat, ice up, short cycle or leak, diagnosed by measurement.](https://clementbostonheatpumps.com/heat-pump-repair/)
- [Service**Air handler replacement** A new indoor unit matched to the outdoor heat pump you already have.](https://clementbostonheatpumps.com/heat-pump-air-handler-replacement/)
- [Service**Heat pump ductwork** Duct testing, sealing, new returns and resized runs so a heat pump gets the air it needs.](https://clementbostonheatpumps.com/heat-pump-ductwork/)

## Get an estimate for heat pump maintenance

Tell us what heats it now and which rooms aren't working. We'll measure, lay out the system and the ducts, and put the plan and the price in writing.

(857) 837-1475
