# Should I replace my boiler with a heat pump?

> Heat pump vs boiler for a Boston-area radiator house, comparing comfort, running cost, cooling, rebates and the duct work a ducted heat pump needs.

URL: https://clementbostonheatpumps.com/guide/heat-pump-vs-boiler/

Decision Guide

Radiator heat is comfortable and long-lived; a ducted heat pump adds cooling and drops the fuel. The ducts are what decide whether the switch is worth it.

Last Updated: November 12, 2026

The short answer

Replace the boiler when it's old, burns oil or propane, or when you want central cooling anyway and the house has attic and basement space for ducts. Keep a sound gas boiler when ducts would be hard to fit; a heat pump can still be added alongside it. For a heat pump vs boiler decision, the ducts set the price.

Key takeaways

- About a quarter of Massachusetts homes heat with a boiler and radiators, and none of them have heating ducts.
- A ducted heat pump replacing a boiler needs new ducts from attic and basement air handlers, or a small-duct system.
- Keeping the boiler as backup is allowed, with an integrated control, under Mass Save's partial-home rebate.
- Against an oil boiler the running-cost case is strong; against gas it's closer.

A house with radiators has no heating ducts, which is why the heat pump vs boiler question is really a question about where ducts could go. [Clement Boston Heat Pumps](https://clementbostonheatpumps.com/) converts boiler houses to ducted heat pumps across Boston and the inner suburbs, and sometimes recommends keeping the boiler for part of the job.

## The two systems side by side

A boiler heats water or steam and sends it to radiators; a ducted heat pump moves heat into air and sends it through registers. Each is good at different things.

|  | Gas or oil boiler with radiators | Ducted cold-climate heat pump |
| --- | --- | --- |
| Heat delivery | Radiators or baseboard, warm surfaces | Registers, moving air |
| Cooling | None; window units or a separate AC | Built in |
| Fuel | Gas or oil burned on site | Electricity |
| Ducts | None needed | Needed: existing, added or small-duct |
| Running cost | Gas lowest; oil highest | Between gas and oil on the winter heat pump rate |
| Mass Save rebate | None for a new boiler | Whole-home or partial-home per ton |
| Typical life of the equipment | Long, especially cast-iron boilers | Shorter, because it runs year-round |

## Why boiler houses are a different job

About 26% of Massachusetts homes heat with a steam or hot-water boiler. None of those houses came with heating ducts.

### Where the ducts go

Ducts come from the top and the bottom of the house. An [attic air handler](https://clementbostonheatpumps.com/attic-air-handler-heat-pump/) serves the top floor through ceiling registers; a basement unit serves the first floor through the floor. Middle floors take a trunk run up a closet or chase.

Where there’s no room for standard ducts, a small-duct high-velocity system runs flexible 2-inch tubes through wall and floor cavities. It fits plaster walls and tight framing better, at a higher equipment cost. See [heat pumps in older houses](https://clementbostonheatpumps.com/guide/heat-pumps-in-old-houses/) and our [ductwork service](https://clementbostonheatpumps.com/heat-pump-ductwork/).

## What it costs to replace a boiler

The ducts make a boiler conversion the most expensive kind of heat pump job. Our typical range for a heat pump with new ductwork or a small-duct system is $20,000 to $40,000 and up before rebates.

### What moves it

- How many floors need ducts, and whether the attic is open or finished
- Small-duct versus standard ducts
- Plaster openings and their repair
- The [electrical panel](https://clementbostonheatpumps.com/electrical-panel-upgrade-for-heat-pump/), since a boiler house often still has 100-amp service
- Removing the boiler, capping the gas or removing the oil tank

The [cost guide](https://clementbostonheatpumps.com/guide/heat-pump-installation-cost-massachusetts/) explains the rest of the price.

## Running cost against oil and gas boilers

The fuel decides this part. Against an oil boiler, a heat pump on the winter rate delivers heat for far less; against a gas boiler, gas stays cheaper per unit of heat.

- **Oil boiler:** the strongest case for switching; see [heat pump vs oil heat](https://clementbostonheatpumps.com/guide/heat-pump-vs-oil-heat/).
- **Gas boiler:** the switch rests on cooling, rebates and the boiler’s age more than fuel savings; see [heat pump vs gas furnace](https://clementbostonheatpumps.com/guide/heat-pump-vs-gas-furnace-massachusetts/) for the same math.
- **Steam boilers:** usually less efficient than hot-water systems, which narrows the gap with a heat pump.

## Three ways to approach a boiler house

You don’t have to choose all or nothing. Three plans fit most radiator homes, and each has its own rebate path.

### Replace the boiler entirely

A whole-home heat pump carries all the heating, the boiler comes out (or stays only for domestic hot water), and the house earns Mass Save’s whole-home rebate. It’s the cleanest result and the biggest job.

### Keep the boiler as backup

The heat pump heats most of the winter through new ducts and cools in summer; an integrated control hands off to the boiler on the coldest nights. Mass Save treats it as partial-home. Keeping some radiators live also keeps hot-water piping in exterior walls from sitting cold.

### Add cooling and shoulder-season heat first

A single attic system on the top floor adds central cooling and carries spring and fall heat, while the boiler keeps doing winter. It’s a smaller first step that sets up a later conversion.

## What happens to the radiators, pipes and hot water

Removing a boiler touches more than the boiler. The radiators, the piping in the walls and the household hot water each need a decision on the estimate.

### Radiators and piping

If the boiler goes, the system is drained so no water sits in pipes along cold exterior walls, and the radiators can stay as decoration or come out room by room. If the boiler stays as backup, the zones that still run keep their water moving, which is the best protection against a frozen pipe.

### Steam systems

Steam radiators run hotter and cycle harder than hot-water baseboard. Pairing steam with a heat pump works, but the control has to stop the two from fighting, and the boiler’s water level and venting still need their usual winter checks.

### Hot water

Many boilers also make the household hot water through a coil or an indirect tank. If the boiler comes out, a separate water heater goes in; under the whole-home rebate, the boiler may instead stay for hot water only.

## How to decide

Three facts usually settle it: the boiler’s fuel and age, whether you want central cooling, and how easily ducts fit. We measure the last one at the first visit, floor by floor.

If the boiler is oil, aging or both, and the attic and basement are open, replacing it with a [boiler to heat pump conversion](https://clementbostonheatpumps.com/boiler-to-heat-pump-conversion/) is usually worth it. If it’s a sound gas boiler in a house with finished attics, keeping it as backup is often the better buy. Call us or send the form to book the visit.

## Questions about this guide

### Will a ducted heat pump work with my existing radiators?

Not directly. A ducted heat pump heats air and delivers it through registers, so it doesn't feed radiators. The radiators can stay as a backup on the boiler, or be removed once the ducted system carries the house. Air-to-water heat pumps that feed radiators are a different system we don't install.

### Can my boiler stay as a backup for a ducted heat pump?

Yes. An integrated control decides when the boiler takes over, usually below a set outdoor temperature. Mass Save treats that as a partial-home project, and keeping some radiators live also protects the hot-water piping from sitting cold and unused in outside walls.

### Is it worth replacing a working steam boiler with a heat pump?

If you want central cooling and the house can take ducts, often yes; you trade a boiler for one system that heats and cools. If the steam system works well and you don't need cooling, a heat pump added for cooling and mild-weather heat is a lower-cost first step.

## Related service

- [Service**Boiler to heat pump conversion** New ducts or small-duct high-velocity runs so a heat pump can heat and cool a radiator house.](https://clementbostonheatpumps.com/boiler-to-heat-pump-conversion/)

## More guides

- [Decision Guide**Is a heat pump better than oil heat in Massachusetts?** Running cost worked out from Massachusetts fuel prices and winter heat pump rates, plus the comfort, cooling, tank and hot water questions that come with the switch.](https://clementbostonheatpumps.com/guide/heat-pump-vs-oil-heat/)
- [Decision Guide**Should I replace my gas furnace with a heat pump in Massachusetts?** Gas is cheap heat per unit, so this comparison turns on cooling, rebates, the age of the furnace and town rules, not the fuel bill alone.](https://clementbostonheatpumps.com/guide/heat-pump-vs-gas-furnace-massachusetts/)
- [Decision Guide**Will a heat pump work in an old house?** Boston has one of the oldest housing stocks in the country. Age changes how a heat pump goes in, not whether it can heat the house.](https://clementbostonheatpumps.com/guide/heat-pumps-in-old-houses/)
- [Decision Guide**Should I get a ducted or ductless heat pump?** Both are heat pumps. The difference is how the heat reaches each room, and that comes down to the ducts you have or could add.](https://clementbostonheatpumps.com/guide/ducted-vs-ductless-heat-pump/)
- [Cost Guide**How much does heat pump installation cost in Massachusetts?** Our typical ranges for Boston-area ducted heat pump jobs, what's inside the price, and what rebates do to it.](https://clementbostonheatpumps.com/guide/heat-pump-installation-cost-massachusetts/)

## Get an estimate for your house

(857) 837-1475
