# What questions should I ask a heat pump installer before I sign?

> The questions that separate Boston-area heat pump quotes, from the load calculation and duct work to permits, old system removal, commissioning and rebates.

URL: https://clementbostonheatpumps.com/guide/heat-pump-quote-checklist/

Decision Guide

Two quotes for the same house can describe very different jobs. These questions show you which one you're actually buying.

Last Updated: November 12, 2026

The short answer

Ask how the system was sized, what happens to the ducts, what electrical work and permits are included, what happens to the old system, how the install will be tested, and which rebate path applies. A quote that answers all six in writing is comparable; one that lists only a brand and a tonnage is not.

Key takeaways

- Sizing should come from a room-by-room load calculation, not the old furnace or AC label.
- Duct changes, electrical work and permits should be listed line by line, not folded into "installation."
- Ask what the commissioning readings will be and whether you'll get them in writing.
- Confirm the installer is in Mass Save's Heat Pump Installer Network before counting on a rebate.

[Clement Boston Heat Pumps](https://clementbostonheatpumps.com/) writes estimates meant to be compared, so use this list on our estimate and on every other one. These are the questions to ask a heat pump installer before you sign, grouped by the part of the job they cover, with what a good answer sounds like and what should make you ask again.

## Sizing: how big, and how do you know?

The right size comes from a room-by-room load calculation for your house, at your town’s design temperature. Everything else in the quote depends on it.

| Ask | A good answer | Ask again if |
| --- | --- | --- |
| How did you size it? | A Manual J load calculation, room by room | “Same as your old unit” or a rule of thumb per square foot |
| What design temperature did you use? | 7°F at Logan, colder inland | No answer, or a southern default |
| What’s the capacity at 5°F? | A listed figure for the exact pair quoted | Only the nominal tonnage |
| Is the equipment on the cold-climate list? | Yes, with the matched indoor unit named | The indoor unit is unnamed |

The [sizing guide](https://clementbostonheatpumps.com/guide/heat-pump-sizing/) explains the calculation, and [SEER2 and HSPF2 ratings](https://clementbostonheatpumps.com/guide/seer2-hspf2-ratings/) explains the numbers on the spec sheet.

## Ducts: reuse, change or add?

A heat pump needs more airflow than most furnaces. A quote that doesn’t mention the ducts hasn’t looked at them.

- Did you measure static pressure and check the return size?
- Which duct changes are included, and where?
- If new ducts are needed, where will they run, and what gets opened?
- Who repairs the walls and ceilings, and is that priced?

Duct work starved of attention shows up as a loud system, cold rooms and backup heat running in winter. See [ductwork for heat pumps](https://clementbostonheatpumps.com/heat-pump-ductwork/).

## Electrical: will my panel carry it?

The heat pump and its backup heat need new circuits, and some houses need a bigger service. The quote should say which.

### What to ask

- What size circuits, and is there room in the panel?
- Does the service need an upgrade, and is it priced?
- Who coordinates with Eversource or National Grid?

Our typical range for an [electrical service upgrade](https://clementbostonheatpumps.com/electrical-panel-upgrade-for-heat-pump/) is $3,000 to $6,500, which is enough to change which quote is really lower.

## Outdoor unit and backup heat

Where the outdoor unit sits and how backup heat is handled both change comfort and running cost, and both belong in writing.

### Placement

- Where will the outdoor unit go, on what mount, and how high above the snow?
- Will it meet the town’s night noise limit at the lot line? Boston’s is 50 dBA.
- How long is the line set, and does it need a cover or a roof route?

### Backup heat

- What backup heat is included: electric strips, or the existing furnace?
- At what outdoor temperature is backup heat locked out?
- What happens on the coldest night, and in a [power outage](https://clementbostonheatpumps.com/guide/heat-pump-power-outage/)?

## Permits and approvals

Every Boston-area heat pump install needs at least one permit, and most need two or three. Ask which ones, and who pulls them.

| Ask | Why it matters |
| --- | --- |
| Which permits are included? | Electrical, sheet metal, building and gas permits each have their own fee and inspection |
| Who pulls them? | In Boston, electrical and sheet metal permits require licensed contractors |
| Do I need historic or condo approval first? | Back Bay, Beacon Hill, the South End and condo boards review outdoor units |

The [installation process](https://clementbostonheatpumps.com/guide/heat-pump-installation-process/) shows how permits fit the schedule.

## The old system: out, off or kept?

The quote should say exactly what happens to the furnace, boiler or old heat pump, and who handles each part.

- Is the old system removed, disconnected, or kept as [dual fuel](https://clementbostonheatpumps.com/dual-fuel-heat-pump/) backup?
- Who caps the gas line, and is a licensed gas fitter doing it?
- What happens to the oil tank, and is the Fire Department permit included?

Mass Save’s whole-home rebate needs the old system removed or disconnected, so these answers decide which rebate you can get. See [oil tank removal](https://clementbostonheatpumps.com/oil-tank-removal/).

## Commissioning: how will you prove it works?

Ask what gets tested before the system is handed over, and whether you’ll get the readings in writing.

1. Nitrogen pressure test on the line set and coil
2. Vacuum below 500 microns, held
3. Refrigerant charge weighed in for the actual line length
4. Airflow and static pressure measured
5. Controls set, and the backup heat lockout recorded

An installer who can’t say what readings you’ll get is telling you something. Those checks matter more to the [lifespan](https://clementbostonheatpumps.com/guide/heat-pump-lifespan/) of the system than the brand on the box.

## Rebates and paperwork

Rebates depend on the installer, the equipment and your utility, so confirm all three before the price in the quote assumes a rebate.

### What to confirm

- Is the installer in Mass Save’s Heat Pump Installer Network?
- Is the equipment on the cold-climate and qualified products lists?
- Which rebate applies: whole-home, partial-home, basic, or a light plant program?
- Does the HEAT Loan need to be in place before work starts?

The [rebate guide](https://clementbostonheatpumps.com/guide/mass-save-heat-pump-rebates/) covers each path, including towns with their own light plant.

## Lining the quotes up

Put the quotes side by side by scope, not by total. Our [cost guide](https://clementbostonheatpumps.com/guide/heat-pump-installation-cost-massachusetts/) shows how each line moves the price.

| Line | Quote A | Quote B |
| --- | --- | --- |
| Load calculation and design temperature |  |  |
| Equipment pair and capacity at 5°F |  |  |
| Duct changes |  |  |
| Electrical and service |  |  |
| Permits |  |  |
| Old system and tank |  |  |
| Commissioning readings |  |  |
| Rebate path |  |  |

A blank line is a question to ask, not a saving. To have us measure the house and write an estimate that fills every line, call us or send the form.

## Questions about this guide

### Should I just take the lowest heat pump quote?

Only if it covers the same work. Low quotes often leave out duct changes, the service upgrade, old system removal or permits, and those come back as change orders or as a system that runs on backup heat. Line the quotes up scope by scope before comparing totals.

### Is it a red flag if an installer sizes the heat pump from my old furnace?

Yes. Old furnaces and AC units were often oversized, and a house that's been insulated or air sealed since needs less. A heat pump sized from the old label tends to short-cycle in mild weather. Ask for the load calculation and the design temperature it used.

### What should a heat pump estimate say about my old heating system?

Whether it's removed or kept as backup, who disconnects it, who caps the gas or oil line, and what happens to an oil tank. Mass Save's whole-home rebate needs the old system removed or disconnected, so a vague answer can cost you the rebate.

## Related service

- [Service**Whole-home heat pumps** One ducted system that heats and cools the whole house, with the furnace or boiler retired.](https://clementbostonheatpumps.com/whole-home-heat-pump/)

## More guides

- [Cost Guide**How much does heat pump installation cost in Massachusetts?** Our typical ranges for Boston-area ducted heat pump jobs, what's inside the price, and what rebates do to it.](https://clementbostonheatpumps.com/guide/heat-pump-installation-cost-massachusetts/)
- [Learn**What happens during a heat pump installation?** Each step in a ducted install depends on the one before it. Here's the order, why it runs that way, and how you can tell the job was done right.](https://clementbostonheatpumps.com/guide/heat-pump-installation-process/)
- [Learn**What size heat pump do I need?** Why square footage and the old unit's tonnage both mislead, what a room-by-room load calculation measures, and how the result turns into equipment.](https://clementbostonheatpumps.com/guide/heat-pump-sizing/)
- [Learn**How do Mass Save heat pump rebates work?** The three rebate tiers, the conditions behind each, the dates that change them, and what happens in towns with their own light plant.](https://clementbostonheatpumps.com/guide/mass-save-heat-pump-rebates/)
- [Learn**What do SEER2 and HSPF2 ratings mean on a heat pump?** Three numbers on every heat pump spec sheet, what each one measures, and the one figure that matters most for a Massachusetts winter.](https://clementbostonheatpumps.com/guide/seer2-hspf2-ratings/)

## Get an estimate for your house

(857) 837-1475
