# Dual fuel heat pump installation in Boston, MA

> A heat pump that heats most of the winter with your gas or oil furnace kept for the coldest hours, run by one integrated control. Priced from your visit.

URL: https://clementbostonheatpumps.com/dual-fuel-heat-pump/

Service

A heat pump paired with the furnace you keep, with one control deciding which one heats.

(857) 837-1475

Last Updated: November 12, 2026

Sized

From a room-by-room load calculation at your town's design temperature

Measured

Duct static pressure and airflow before and after

Tested

Nitrogen pressure test and deep vacuum before the charge

In writing

Equipment, duct work, electrical and permits listed line by line

## What a dual fuel job in Savin Hill looks like

Matched coil set on top of the six-year-old gas furnace

New heat pump outdoor unit on a stand in the narrow side yard

### A young furnace, a dead AC

A Victorian on the Savin Hill slope above the bay, with a six-year-old two-stage gas furnace and a 19-year-old AC that has finally quit. The furnace has years left. The owner wants heat pump heating and summer cooling back without paying to scrap good, young equipment.

### Why not all-electric

The drafty balloon-framed walls push the heating load to 46,000 BTU an hour on a 7°F night, while cooling needs only 2.6 tons. A heat pump big enough for January oversizes summer and needs strips the 100-amp panel can't carry. So a 3-ton heat pump goes in with the furnace as backup.

### The work

The R-22 condenser and leaking coil come out. A matched cased coil goes on the furnace's 17.5-inch cabinet, a new 35-foot line set runs to an 18-inch stand nine feet from the rear lot line, and a listed integrated control with an outdoor sensor ties the two systems together.

### Where the hand-off sits

At 3 tons the heat pump carries the house down to about 14°F. The control keeps it primary and calls the furnace only below the switchover, set within the partial-home rules and written into the closeout. The furnace venting gets its own combustion check, and the rebate is about $3,375.

*Project facts*

| Service | Dual fuel heat pump |
| --- | --- |
| Where | Savin Hill, Dorchester |
| House | 1900s Victorian, about 1,950 sq ft |
| Before | 6-year-old gas furnace, dead 19-year-old AC |
| After | 3-ton cold-climate heat pump on the kept furnace |
| Price | $13,900 before rebates |
| Time on site | Two working days |

Your gas furnace is six years old and runs fine, the central AC just quit, and you’d like heat pump heating without scrapping a good furnace. A dual fuel heat pump does that. [Clement Boston Heat Pumps](https://clementbostonheatpumps.com/) adds a heat pump that heats most of the winter and hands the coldest hours to the furnace you already own.

We price dual fuel from what stays and what changes: the outdoor unit, a coil on the furnace, the controls and the line set. The written estimate after the home visit sets the number.

## How the heat pump and furnace share the work

The heat pump heats the house until the outdoor temperature drops to a set point, then the furnace takes over. Both use one blower, one coil cabinet and one set of ducts, and in summer the heat pump cools.

### The balance point

Every house has an outdoor temperature where the heat it loses equals what the heat pump can deliver. Above it, the heat pump carries the house alone. Below it, something has to add heat. The load calculation and the equipment’s published output at 17°F and 5°F tell us where that point falls.

### The switchover temperature

The switchover is the setting where the control hands off to the furnace. It can sit at the balance point, below it or above it, depending on comfort, fuel prices and rebate rules. With the coil on top of the furnace, the two never heat at once, because furnace heat across that coil overloads the heat pump.

## Keep the furnace or go all-electric?

Keep it when it’s young and the house is hard to heat with one heat pump. Retire it when it’s near the end, when your town limits fossil equipment in your renovation, or when you want a single electric bill.

- **Dual fuel fits** a furnace under about ten years old, a large or drafty house, a panel with little room for electric strips, or an owner who wants a gas or oil backup on hand.
- **[Whole-home](https://clementbostonheatpumps.com/whole-home-heat-pump/) fits** an old furnace, a house weatherized enough for one heat pump, or an owner after the larger whole-home rebate.

### What it costs to run

The fuel you keep decides how much dual fuel saves. Next to oil or propane, heat from a heat pump costs less through most of the winter. Next to gas at current Boston prices, the gap is narrow, and in deep cold gas heat can cost less. Our [heat pump vs gas furnace guide](https://clementbostonheatpumps.com/guide/heat-pump-vs-gas-furnace-massachusetts/) runs the numbers.

### Town rules

Arlington, Brookline, Cambridge, Newton, Lexington and Concord limit new fossil-fuel equipment in new buildings and major renovations. Keeping an existing furnace in an ordinary retrofit isn’t affected; putting in a new furnace during a gut renovation there is. [Medford](https://clementbostonheatpumps.com/service-areas/medford/) and [Watertown](https://clementbostonheatpumps.com/service-areas/watertown/) still allow dual fuel with new equipment.

## Gas, oil or a boiler as the backup

The backup can be a gas furnace, an oil furnace or a boiler feeding a hot-water coil. Each pairs with the heat pump a little differently.

- **Gas furnace.** The usual pairing. The heat pump’s coil sits on the furnace outlet, and the furnace blower moves air for both.
- **Oil furnace.** The same layout. Because oil heat costs more per unit, the switchover can sit low and the burner runs only on the coldest nights.
- **Boiler with hydro-air.** Some houses have an air handler with a hot-water coil fed by the boiler. A heat pump air handler takes its place, with a boiler-fed coil kept in the airstream as the backup. The boiler still serves radiator zones and, in many houses, the hot water.

Combustion safety stays its own check. When a coil goes on a furnace, the venting, draft and heat exchanger are looked at separately, and a licensed gas fitter handles anything on the gas side. Hydro-air houses also have a [boiler conversion](https://clementbostonheatpumps.com/boiler-to-heat-pump-conversion/) option if the boiler is due.

## What the first visit checks for dual fuel

We size the heat pump from the house and design around the backup that’s already there. The visit covers the load, the furnace, the ducts, the panel and the outdoor spot.

- A room-by-room Manual J at your town’s design temperature, so the balance point is known before equipment is picked.
- The furnace’s age, input, blower type and cabinet width, which decide the coil and whether the blower can deliver heat pump airflow.
- Static pressure on the ducts; dual fuel doesn’t excuse a choked return, so fixes go on the estimate as [ductwork](https://clementbostonheatpumps.com/heat-pump-ductwork/) lines.
- The panel. Without electric strips, a dual fuel heat pump adds less load, which can avoid a service upgrade.
- The outdoor spot, above drifting snow and inside your town’s noise limit.

## Integrated controls and the partial-home rebate

Mass Save pays a partial-home rebate when a heat pump heats a home that keeps oil, propane or gas, provided an integrated control runs the two. The control has to be on the program’s list and set at or below its maximum switchover temperature.

Through 2026 the partial-home rebate is $1,125 per ton up to $8,500; from January 1, 2027 it steps down to $1,000 per ton up to $7,500. We install qualifying cold-climate equipment as a participating contractor in Mass Save’s Heat Pump Installer Network.

### Why the control matters

Two separate thermostats, or a basic changeover, can let the furnace take over on mild days and erase the savings. An integrated control reads the outdoor sensor, keeps the heat pump primary and calls the furnace only below the setting. We record the switchover in your closeout papers so anyone servicing the system later can see it.

Gas-heated homes apply through the gas sponsor; oil and propane homes through the electric sponsor. Light plant towns run their own programs. Our [rebate guide](https://clementbostonheatpumps.com/guide/mass-save-heat-pump-rebates/) lays out each path, and [aux heat](https://clementbostonheatpumps.com/guide/heat-pump-aux-heat/) explains what the thermostat display means.

## When dual fuel is the wrong fit

When the furnace is near the end, dual fuel pairs a new heat pump with an old burner you’ll replace soon anyway. When the ducts can’t carry heat pump airflow, the ducts come first.

It’s also a poor match if you plan to drop gas service within a few years; a [furnace-to-heat-pump conversion](https://clementbostonheatpumps.com/furnace-to-heat-pump-conversion/) is cleaner then. And an aging oil furnace with an old tank often points to an [oil-to-heat-pump conversion](https://clementbostonheatpumps.com/oil-to-heat-pump-conversion/) with the [tank removed](https://clementbostonheatpumps.com/oil-tank-removal/).

## What's included

- A load calculation that shows where the heat pump stops carrying the house alone
- A check of the furnace's age, blower and cabinet before we design around it
- A cold-climate outdoor unit on a stand above drifting snow
- A matched coil on the furnace, a new line set and a condensate trap
- An integrated control and outdoor sensor wired to both systems
- Furnace blower set to heat pump airflow, measured at startup
- Switchover temperature set and written into your closeout papers
- Both heating modes and cooling tested before we leave

## Dual fuel next to the other ways to heat a ducted house

|  | Dual fuel (heat pump and furnace) | All-electric heat pump | Furnace with central AC |
| --- | --- | --- | --- |
| Below the switchover | The furnace heats | The heat pump, with electric strips | The furnace heats all winter |
| Added panel load | Outdoor unit only, no strips | Outdoor unit plus strips | AC condenser |
| Mass Save path | Partial-home, per ton | Whole-home, per ton | No heat pump rebate |
| Best fit | A furnace with years left | A furnace near the end | Owners not ready to switch |
| Fossil-fuel-free towns | Existing furnace may stay in a retrofit | Always allowed | New furnace limited in major renovations |

## Related resources

- [Decision Guide**Should I replace my gas furnace with a heat pump in Massachusetts?** Gas is cheap heat per unit, so this comparison turns on cooling, rebates, the age of the furnace and town rules, not the fuel bill alone.](https://clementbostonheatpumps.com/guide/heat-pump-vs-gas-furnace-massachusetts/)
- [Learn**Why does my heat pump's aux heat keep coming on?** Backup heat is part of every cold-climate system. Here's when it should run, when it shouldn't, and the settings that decide which.](https://clementbostonheatpumps.com/guide/heat-pump-aux-heat/)
- [Learn**What thermostat do I need for a heat pump, and how should I set it?** The control decides whether a heat pump runs on its compressor or on expensive backup heat. Here's what it has to do and how to set it for a Massachusetts winter.](https://clementbostonheatpumps.com/guide/heat-pump-thermostat/)
- [Learn**How do Mass Save heat pump rebates work?** The three rebate tiers, the conditions behind each, the dates that change them, and what happens in towns with their own light plant.](https://clementbostonheatpumps.com/guide/mass-save-heat-pump-rebates/)
- [Decision Guide**Should I replace my boiler with a heat pump?** Radiator heat is comfortable and long-lived; a ducted heat pump adds cooling and drops the fuel. The ducts are what decide whether the switch is worth it.](https://clementbostonheatpumps.com/guide/heat-pump-vs-boiler/)

## How a job runs

### First call

You tell us what heats and cools the house now, which rooms aren't working, and roughly where the house is.

### Home visit

We measure the house for a load calculation, test the ducts, check the panel and look for an outdoor spot.

### Written estimate

Equipment, duct changes, electrical, permits and the rebate path, line by line, with our price.

### Install

Permits first, then the work: usually two to five working days on site.

### Commissioning

Pressure test, vacuum, charge by weight, airflow and controls set before we call it done.

## Dual fuel heat pumps: questions

### What temperature should a dual fuel system switch to the furnace?

It depends on the house, the fuel and the rebate. The load calculation gives the balance point, where the heat pump stops keeping up alone. For Mass Save's partial-home rebate, the integrated control must be set at or below the program's maximum switchover temperature. We set it, then write it down.

### Can I add a heat pump to an oil furnace?

Yes. The heat pump's coil goes on the oil furnace the same way it does on a gas one, and an integrated control runs both. Oil heat costs more per unit than heat pump heat in most weather, so the heat pump carries most of the season and the burner runs only in deep cold.

### Does my furnace need replacing to go dual fuel?

Not if it's in good shape and its blower can deliver heat pump airflow. A variable-speed blower is easiest to set. A furnace near the end of its life, or one whose cabinet can't take a matched coil, is a reason to look at an all-electric system instead.

### Does a dual fuel heat pump get a Mass Save rebate?

Yes, the partial-home rebate, when the system has a listed integrated control and qualifying cold-climate equipment installed by a participating contractor. Through 2026 it pays $1,125 per ton up to $8,500; from January 1, 2027, $1,000 per ton up to $7,500.

### Will a dual fuel system heat the house in a power outage?

No. The heat pump needs power, and a gas or oil furnace also needs it for its blower, igniter and controls. A dual fuel setup does use less electricity on cold nights, so a backup generator sized for the furnace can keep the house warm while the heat pump waits.

## Related services

- [Service**Whole-home heat pumps** One ducted system that heats and cools the whole house, with the furnace or boiler retired.](https://clementbostonheatpumps.com/whole-home-heat-pump/)
- [Service**Furnace to heat pump conversion** Take out the gas or propane furnace and heat and cool through the same ducts with a heat pump.](https://clementbostonheatpumps.com/furnace-to-heat-pump-conversion/)
- [Service**Replace AC with a heat pump** When the central AC dies, a heat pump on the same ducts cools and adds a second source of heat.](https://clementbostonheatpumps.com/replace-ac-with-heat-pump/)

## Get an estimate for dual fuel heat pumps

Tell us what heats it now and which rooms aren't working. We'll measure, lay out the system and the ducts, and put the plan and the price in writing.

(857) 837-1475
